Round_FlatFlange Sheet - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D HVAC Reference Data

Language
English
Product
Intergraph Smart 3D
Subproduct
HVAC
Search by Category
Reference Data
Smart 3D Version
11 (2016)

The Round_FlatFlange sheet in the HVAC.xls workbook defines the round flat flanges available in the Catalog.

PartNumber

Type the part number for the flange. An example is ROUNDFF for round flat flange.

SymbolDefinition

Type the symbol definition for the round flat flange.

FaceDepth

Type the face depth for the coil.

FaceWidth

Type the face width for the coil.

ComponentType

Type the component type for the round flat flange.

PartDescription

Type a description for the round flat flange.

Width

Type the width of the duct.

Clearance

Type the clearance for the round flat flange.

FlangeWidth

Type the width of the flange.

Thickness

Type the thickness for the flange.

CompressedGasket

Type the thickness for the compressed gasket.

For the remaining properties, (i) indicates an integer corresponding to a nozzle number assigned to the cross section. This method avoids a lengthy listing for all possibilities, like Nozzle(1):CrossSection, Nozzle(2):CrossSection, and Nozzle(3):CrossSection for three possible nozzles. When you type the nozzle properties in the workbook, substitute a number for i to assign the nozzle to the appropriate property.

Nozzle(i):CrossSection

Type the related CrossSection object for the port.

Nozzle(i):EndPrep

Type the coded end preparation for the nozzle. Examples of end preparations include Threaded, Screwed, Plain End, Welded, Bolted, Female, Male, and Ferule. In the reference data, a number represents each type of end preparation (for example, 1 for Threaded, 2 for Screwed and so on).

Nozzle(i):Thickness

Type the thickness of for the particular nozzle port.

Nozzle(i):FlangeWidth

Type the flange width for the nozzle.

Nozzle(i):FlowDirection

Type the flow direction for the nozzle.

Nozzle(i):PortDepth

Type the depth of the port for nozzle.

Nozzle(i):CptOffset

Type the offset value for the component.