Specifies the default values for the bracket flange parameters. Values can be modified as permitted by the catalog. This tab is only visible after bracket creation and only if the bracket has a flange.
Molded Surface Side
Sets the molded side of the bracket and bracket flange. Supports creation of the flange symbol at the correct location while accounting for molded convention thickness direction and offset values.
If the molded side is the inner surface, the value is 0.
If the molded side is the outer surface, the value is 1.
Flange Width
Width of the flange measured from the edge of the bracket symbol, which is also the first bend tangent.
Plate Thickness
Specifies the thickness of the plate.
Bend Angle
Angle between the flange surface and bracket surface.
Inner Radius
Bend radius measured along the inner surface of the bend.
1 |
FlangeWidth |
2 |
PlateThickness |
3 |
BendAngle |
4 |
InnerRadius |
One option is also displayed.
Flange Orientation
Select the orientation of the flange bracket.
Same As Parent
Orientation is the same as the bracket plate system primary profile orientation.
Against Parent
Orientation is in the opposite direction of the bracket plate system primary profile orientation.