External Editor Installation - Intergraph Smart Instrumentation - 13.1 - Installation & Upgrade - Intergraph Process, Power & Marine Documentation

Intergraph Smart Instrumentation External Editor Installation

English (United States)
Intergraph Smart Instrumentation
Search by Category
Installation & Upgrade
Smart Instrumentation Version

External Editor enables a third party (contractor, engineering company, and so forth) to modify your process data sheets and the unprotected fields of your specification sheets without the need to use the Intergraph Smart® Instrumentation software program or a special report generator.

Using External Editor, you can open a process data or specification sheet and modify it. After modification, you save to the same file or to a new file.  You can then reopen the file in Smart Instrumentation for further processing. You can also print process data and specification sheets from External Editor.

External Editor is a stand-alone program that you need to install in order to use it.  This document describes the hardware requirements for installing External Editor.  In addition, this document provides step-by-step instructions on how to install and uninstall External Editor.

To successfully run External Editor, you must have read/write access rights to the folder where External Editor is installed.

Customer Support
Hexagon PPM Policy Against Software Piracy
Copyright © 1998-2020 Hexagon AB and/or its subsidiaries and affiliates
Version 13.1
Published 12/9/2021 at 7:05 AM