CADWorxP&ID tab: Text > Text Correction
Misc toolbar: Text Correction
Command line: TEXTCORRECT
Modifies a text attribute of a block (symbol). This command is not used with text created with Small , Medium , and Large .
Right-click or type in the command line to select one of the following options:
Multiple
Allows selection of all attributes of a block for modification. You must then right-click or type in the command line to select another option (Height, MOve, Flip, Rotate, or Layer).
Height
Modifies the text height of an attribute.
Move
Moves an attribute.
Flip
Flips an attribute. Flipping attributes is required after a block has been mirrored.
-
When blocks are mirrored with Flip Symbol , the attributes are also mirrored. Flip returns the attributes back to their original orientation. For more information, see Flip Symbol.
-
When creating blocks, use the Centered alignment point for attributes. Attributes then flip around the center alignment, leaving the attribute in the same location. When left or right alignment is used, the attribute shifts to the right or left when flipping.
Rotate
Rotates an attribute within the block. Pick two points to establish the angle, or enter a value.
Layer
Changes the layer of an attribute.
What do you want to do?