Place Center Point Only - Intergraph Smart Review - Help

Intergraph Smart Review Help

PPMProduct
Intergraph Smart Review
PPMCategory_custom
Help
SPFVersion_custom
2019 (10.0)
Version_SPR
2020 (15.0)

View > Place > Center Point Only

Places the center point of the view at the located point without adjusting the eye point. The model coordinates of the mouse position display in the status bar. The view cone displays in the Plan and Elevation views while you position it.

If the eye and center points get too close, some viewing operations cease to function properly. To correct this problem, place a new center point, enter new values for the eye and center
points and viewing angles on the View > Settings > View Cone tab, or use the Position Control toolbar to adjust the eye point, center point, and viewing angles.

See Also

Using the View Cone
Set Center Point
Set View Cone Display
Position Control Toolbar