Select
Selects an existing geometric construction object, such as a curve or surface, to edit or delete.
Add
Selects geometry that defines a new geometric construction. This option is used with the numbered step options listed below.
Delete
Deletes a selected geometric construction.
Cancel
Cancels the macro, closes the geometric construction ribbon and the Geometric Construction Palette dialog box, and then returns to the main command ribbon.
Close
Verifies the validity of values selected for the options, closes the geometric construction ribbon and the Geometric Construction Palette dialog box, and then returns to the main command ribbon. The selected values are still available when you click again on the main command ribbon.
Geometric Construction
Displays the current geometric construction interface. You can also select:

A different, recentlyused interface.

More  Opens the Select Geometric Construction dialog box. For a new geometric construction, all interfaces delivered with the software are available. For an existing geometric construction, only similar interface types are available.
Geometric constructions displaying only in the Select Geometric Construction dialog box are not intended for general usage. You should first consult your Intergraph support representative before using these geometric constructions.
1
Specifies an intersecting surface or reference plane.
2
Specifies the intersected surface or reference plane. By default, this is the surface of the plate selected for the main command.
Specifies a coordinate system used to orient the curve. This value is optional and is not available when Keep all curves is selected for Curve Option.
Specifies a tracking point used to control the direction of curve placement when an ambiguity exists. A tracking point is only needed with curved surfaces that intersect more than once. The tracking point is used with the value selected by Track Flag. This value is optional and is not available when Keep all curves is selected for Curve Option.
The selected tracking point must be an existing point previously created with Insert > Control Point, Insert > Topological Points, or other geometric construction point interfaces.
Reject
Clears the selections for the current step.
Accept
Accepts the current selections and displays a preview.
Continue
Completes the geometric construction definition. The ribbon continues to display so that you can define parameters for additional geometry.
The geometric constructions are not created and saved to the model until you click Finish on the main command ribbon to create the model object.
Track Flag
Controls how the tracking point is used when the Curve Option of Keep one curve is selected and an ambiguity exists. Select Near to use the curve nearest to the tracking point. Select Far to use the curve farthest from the tracking point.
Curve Option
Controls the number of curves that are created when an ambiguity exists. Select Keep one curve to create one curve based on the selected value of Track Flag and the selected tracking point. Select Keep all curves to create all possible curves.