Value |
Bounded Outer Surface Intersects Edge |
Bounded Outer Surface Intersects Nothing |
Bounded Outer Surface Intersects Corner |
No Bounded Flange |
---|---|---|---|---|
None |
||||
The purpose is to maintain maximum contact between the bounded and bounding objects. |
||||
EdgeToFlange |
||||
The purpose is to leave the bounded flange connected, if it exists, and clear material just inside the bounded flange, while leaving the bounded web attached to the bounding edge if there is any overlap. If the overlap is insufficient for the default feature, the answer is not applicable, and no feature should be placed. If there is no flange, it should behave like Edge To Outside. |
||||
EdgeToOutside |
||||
The purpose is to disconnect the bounded flange, if it exists, and leave part of the bounded web attached to the edge of the bounding flange if there is any overlap. If there is no overlap, then the flange is set back starting at the corner, but no additional material is removed from the web (compare to Corner To Outside). |
||||
CornerToFlange |
||||
The purpose is to leave the bounded flange connected, if it exists, and disconnect the bounded web from the edge of the bounding edge if there is any overlap. If the overlap is insufficient for the default feature, the answer is not applicable, and no feature should be placed. If there is no flange, it should behave like Corner To Outside. |
||||
CornerToOutside |
||||
The purpose is to disconnect the bounded flange, if it exists, and disconnect the bounded web from the edge of the bounding edge if there is any overlap. |
||||
OutsideToEdge |
||||
The purpose is to leave the bounded flange connected, if it exists, and clear material in the immediate vicinity of the bounding corner. If the overlap at the bounding edge is insufficient for the default feature, it should behave like Outside To Outside. |
||||
OutsideToFlange |
||||
The purpose is to disconnect the bounded flange, if it exists, and clear material in the vicinity of the bounding inside corner. If there is no flange, it behaves like Outside To Outside. |
||||
OutsideToOutside |
||||
The purpose is to disconnect the bounded flange, if it exists, and clear material in the immediate vicinity of the bounding edge and the outside corner of the bounding edge. |