Angled Notch Corner - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

IJUAhsTLCorner1::TLCornerType1

Specifies the corner type for the angled notch. TLCornerType1 uses codelist values 2, 3, or 5. See the hsCornerShape sheet from the HS_S3DParts_Codelist.xls workbook for all the valid codes.

Codelist hsCornerShape 2 – Rectangular Notch

IJUAhsTLCorner1::TLCornerX1 -

Codelist Value

2

3

4

5

Corner Type

XY Chamfer

XY Edges

X with an Angle

Y with an Angle

X

Description of X

Size of chamfer

Size of straight edge

Size of chamfer

Angle from vertical

Limits of X

X > 0

X >= 0

X > 0

X > 0

(Angle in degrees)

X <= Width1

X < Width1

X <= Width1

Calculated X <= Width1

IJUAhsTLCorner1::TLCornerY1 -

Codelist Value

2

3

4

5

Corner Type

XY Chamfer

XY Edges

X with an Angle

Y with an Angle

Y

Description of Y

Size of chamfer

Size of straight edge

Angle from vertical

Size of chamfer

Limits of Y

Y > 0

Y >= 0

Y > 0

(Angle in degrees)

Y > 0

Y <= Length

Y < Length

Calculated Y <= Length

Y <= Lenght

IJUAhsTLCorner1::TLCornerRadius1

Specifies the radius of the angled notch shape. Use this when the two outside points of the notch must be rounded using the corner radius value. You must set the radius small enough to allow tangents on the top, the left, and the slanted face. If this value is set to zero, then the software draws a sharp corner. This value cannot be negative.