IJUAhsTLCorner::TLCornerType
Specifies the corner type. Enter codelist value 2, 3, 4, or 5 for this corner type. Valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsCornerShape sheet.
Codelist hsCornerShape 2 – Angled Notch
IJUAhsTLCorner::TLCornerX
Codelist Value |
2 |
3 |
4 |
5 |
Corner Type |
XY Chamfer |
XY Edges |
X with Angle |
Y with Angle |
X |
||||
Description of X |
Size of chamfer |
Size of straight edge |
Size of chamfer |
Angle from vertical |
Limits on X |
X > 0 |
X >= 0 |
X > 0 |
X > 0 (angle in degrees) |
X <= Width1 |
X < Width1 |
X <= Width1 |
Calculated X <= Width1 |
IJUAhsTLCorner::TLCornerY
Codelist Value |
2 |
3 |
4 |
5 |
Corner Type |
XY Chamfer |
XY Edges |
X with Angle |
Y with Angle |
Y |
||||
Description of Y |
Size of chamfer |
Size of straight edge |
Angle from vertical |
Size of chamfer |
Limits on Y |
Y > 0 |
Y >= 0 |
Y > 0 (angle in degrees) |
Y > 0 |
Y <= Length |
Y < Length |
Calculated Y <= Length |
Y <= Length |
IJUAhsTLCorner::TLCornerRadius
Specifies the radius of the angled notch shape. Enter this value when the two outside points of the notch need to be rounded using this radius. You must set the radius small enough to allow tangents on top, left, and slanted face. If this value is set to zero, then a sharp corner will be drawn by the software. The value cannot be negative.