Basic Turnbuckle Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

The following properties are used for the part selection rule and the location of the ports. You must enter the values to get a correct port location and for the selection of turnbuckle part based on part selection rule.

The default unit of distance for these properties is "mm". Use "in" to specify inches for the dimensional value.

IJUAhsRodDiameter::RodDiameter

Defines the outside diameter of the rod that attaches to the turnbuckle. This value is used only for part selection rules for choosing the correct turnbuckle part and has no impact on creating graphics. For reducing couplers, you must enter the larger rod diameter.

The rod is not modeled in the turnbuckle's graphics.

IJUAhsRodTakeOut::RodTakeOut

Defines the distance between the ports. This value represents the amount that the turnbuckle takes out of the overall rod lengths. If this value is set to zero, such as for a coupler, then the ports will be located with a small space between them.

IJUAhsOpening1::Opening1

Defines the inside distance between the two nuts. This value can be set to zero.