Side Feature Shape Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties specify the side feature shapes properties for the Strut_A. Define values only when the side shape is needed.

IJUAhsLoc1:Loc1X

Enter the X coordinate distance for the start position of the center (not the edge) of the side nut shape.

IJUAhsLoc1:Loc1Y

Enter the Y coordinate distance for the start position of the center (not the edge) of the side nut shape.

IJUAhsLoc1:Loc1Z

Enter the Z coordinate distance for the start position of the center (not the edge) of the side nut shape.

The black dot in the figure represents the Loc1 position, which might have XYZ values of (-5.5", 0", 12") for example.

IJUAhsDirection1::Direction1

Specifies the orientation direction of the side nut shape relative to the LOC1 start position. In the example figure above, the shape runs in the positive Z direction from the start position. The values for this property are in the HS_S3DParts_Codelist.xls on the hsDirection sheet.

0 is positive X
1 is negative X
2 is positive Y
3 is negative Y
4 is positive Z
5 is negative Z