Selection Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.x(2018)

These properties specify for the part selection properties and for report properties for the Strut_A. Enter these properties to select the correct part from an Assembly Information Rule (AIR) and used for Reporting purpose.

IJUAhsStroke::Stroke

Enter the stroke of the snubber. This value is used by the AIR for the part selection of the snubbers.

IJOAhsExtension::Extension

Enter the extension distance for snubbers due to thermal movement from cold to hot. This value is used to compare the travel of the snubber against the stroke of the snubber and is required for ordering.

IJOAhsRetraction::Retraction

Enter the retraction distance for snubbers due to thermal movement from cold to hot. This value is used to compare the travel of the snubber against the stroke of the snubber and is required for ordering.

IJUAhsAllowance::Allowance

Enter the excess travel allowance, for example 20%. A warning is displayed if (extension + retraction) times (one + allowance) is greater than stroke.

IJOAhsSetPosition::SetPosition

Enter the set position that is used for purchasing. This value is used for reporting.