Rounded Notch Corner (Concave) - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

IJUAhsTLCorner::TLCornerType

Specifies the corner type. Enter codelist value 6 for this corner type. Valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsCornerShape sheet.

IJUAhsTLCorner::TLCornerX

Specifies the horizontal offset of the round notch center point. You cannot offset the round notch off the plate in either direction. If you want both corners to be round notch as shown below, then the value must be less than Width1 divided by 2.

If this value is set to zero, then the notch center will be aligned with the corner point. The notch shape will be a quarter-circle arc.

X = 0, Zero Offset

If a positive value is set, then the software will move the center point into the plate horizontally. This adds a flat landing in addition to the quarter-circle arc.

X > 0, Positive Offset

If a negative value is set, then the software will move the center point away from the plate horizontally. This will reduce the sweep angle of the notch shape so it will be less than a quarter-circle and the joint with one edge is no longer perpendicular.

X < 0, Negative Offset

IJUAhsTLCorner::TLCornerY

Specifies the vertical offset of the round notch center point. You cannot offset the round notch off the plate in either direction.

If this value is set to zero, then the notch center will be aligned with the corner point. The notch shape will be a quarter-circle arc.

Y = 0, Zero Offset

If a positive value is set, then the software will move the center point into the plate vertically. This adds a flat landing in addition to the quarter-circle arc.

Y > 0, Positive Offset

If a negative value is set, then the software will move the center point away from the plate vertically. This will reduce the sweep angle of the notch shape, so it will be less than a quarter-circle and the joint with one edge is no longer perpendicular.

Y < 0, Negative Offset

IJUAhsTLCorner::TLCornerRadius

Specifies the radius of the round notch shape.

If the radius is needed in X + direction, the value must be greater than zero and less than that of available Width1.

If the radius is needed in Y + direction, the value must be greater than zero and less than that of available Length1.

If this value is set to zero, then the software will create a sharp corner edge.