Angled Notch Corner - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

IJUAhsTLCorner::TLCornerType

Specifies the corner type. Enter codelist value 2, 3, 4, or 5 for this corner type. Valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsCornerShape sheet.

Codelist hsCornerShape 2 – Angled Notch

IJUAhsTLCorner::TLCornerX

Codelist Value

2

3

4

5

Corner Type

XY Chamfer

XY Edges

X with Angle

Y with Angle

X

Description of X

Size of chamfer

Size of straight edge

Size of chamfer

Angle from vertical

Limits on X

X > 0

X >= 0

X > 0

X > 0 (angle in degrees)

X <= Width1

X < Width1

X <= Width1

Calculated X <= Width1

IJUAhsTLCorner::TLCornerY

Codelist Value

2

3

4

5

Corner Type

XY Chamfer

XY Edges

X with Angle

Y with Angle

Y

Description of Y

Size of chamfer

Size of straight edge

Angle from vertical

Size of chamfer

Limits on Y

Y > 0

Y >= 0

Y > 0 (angle in degrees)

Y > 0

Y <= Length

Y < Length

Calculated Y <= Length

Y <= Length

IJUAhsTLCorner::TLCornerRadius

Specifies the radius of the angled notch shape. Enter this value when the two outside points of the notch need to be rounded using this radius. You must set the radius small enough to allow tangents on top, left, and slanted face. If this value is set to zero, then a sharp corner will be drawn by the software. The value cannot be negative.