Curved Base Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

These properties are used to create curved base geometry of the saddle. If these properties are left as blank or 0, then the part creates the dimensions based on the rules provided in the symbol code.

IJUAhsAngle1::Angle1

Specifies the angle from vertical center line of the pipe to the left leg of the saddle. Angle1 and Angle2 properties define the sweep of the saddle.

If ToEdge is set to Yes, then the sweep angle is calculated to the edge of the leg. Otherwise the sweep angle is calculated to the center of the leg.

Angle1 plus Angle2 is always greater than or equal to 180 degrees.

IJUAhsAngle2::Angle2

Specifies the angle from vertical center line of the pipe to the right leg of the saddle.

IJUAhsAngle3::Angle3 (Optional)

Specifies the angle from vertical center line of the pipe to the left edge of the curved plate. Angle3 and Angle4 properties define the sweep of the lower curved plate.

Angle3 is always greater than Angle1, and Angle3 plus Angle4 is always less than or equal to180 degrees.

IJUAhsAngle4::Angle4 (Optional)

Specifies the angle from vertical center line of the pipe to the right edge of the curved plate.

IJUAhsToEdge::ToEdge

Indicates whether or not the software calculates the sweep angle of the saddle from the edge of the leg. This property uses the codelist value defined in the hsYesNo sheet in the HS_S3DParts_Codelist.xls file.