IJUAhsThickness1::Thickness1
Specifies thickness of the lower curved plate. This value must be greater than zero.
IJUAhsLength1::Length1
Specifies the length of the lower plate. This value must be greater than or equal to zero.
IJUAhsAngle1::Angle1
Specifies the angle from vertical center line of the pipe to the left edge of the plate. Angle1 and Angle2, or Width1 and Width2, can define the sweep of the plate. Angle1 and Angle2 take precedence. If there is no top plate then:
Angle1 <= 360 degrees – Angle2
Else if there is a top plate then
Angle1 <= 180 degrees – Angle3
IJUAhsAngle2::Angle2
Specifies the angle from vertical center line of the pipe to the right edge of the plate. Angle1 and Angle2, or Width1 and Width2, can define the sweep of the lower plate. Angle1 and Angle2 take precedence. If there is no top plate then:
Angle2 <= 360 degrees – Angle1
Else if there is a top plate then
Angle2 <= 180 degrees – Angle4
IJUAhsWidth1::Width1
Specifies the distance from vertical center line of the pipe to the left inside edge of the plate. Curved plate only drawn on the lower half of the pipe. Angle1 and Angle2 must be 0 or this will be ignored. Width1 must be less than 0.5 * PipeOD.
IJUAhsWidth2::Width2
Specifies the distance from vertical center line of the pipe to the right inside edge of the plate. Curved plate only drawn on the lower half of the pipe. Angle1 and Angle2 must be 0 or this will be ignored. Width2 must be less than 0.5 * PipeOD.