These properties define the geometry of the strap.
IJUAhsStrap::StrapWidthInside
Specifies the inside distance between the legs of the strap. This value is greater than PipeOD.
IJUAhsStrap::StrapHeightInside
Specifies the inside height from the base of the strap to the top.
IJUAhsStrap::StrapThickness
Specifies the thickness of the rectangular stock used to make the strap. This value cannot be zero.
IJUAhsStrap::StrapStockWidth
Specifies the width of the rectangular stock used to make the strap. This value cannot be zero.
IJUAhsStrap::StrapFlatSpot
Adds a flat spot in the curved part of the strap. This value can be less than or equal to StrapWidthInside. If it is set to zero, then no flat spot is shown on the curved part of the strap. If it is set to a positive value, a flat spot is added in the curved section of the strap as shown in Fig. 1. If it is set to StrapWidthInside, then the strap is drawn like three plates with no corner rounding as shown in Fig.2.
IJOAhsStrapGap::StrapTopGap
Specifies the gap between outside of pipe and inside of the strap.
IJUAhsStrap::StrapWidthWings
Specifies the width to the outside of the wings. If this value is set to zero, or less than StrapWidthInside + 2* StrapThickness, the strap wings are not shown.
IJUAhsStrap::StrapOneSided
Standard Yes or No codelist. If this value is set to Yes, the right side of the strap is not shown below the tangent point. Wings, bolts, and gussets are not included in the right side if StrapOneSided is set to Yes.
IJUAhsStrap::StrapSplitGap
Specifies the gap at the top and splits the strap into two parts.
IJUAhsStrap::StrapSplitExtension
Specifies the length of the tabs from the top inside of the strap to the end of the tabs.