Strap Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

If the straps are included, then you always have two round straps. The strap graphic is covered by the base graphic if the base graphic is included. Both straps have the same dimensions. Not all dimensions are required. If a dimension is blank or equal to zero, the part creates the dimension based on the provided rule. If no rule is provided, the part ignores the dimension.

IJUAhsWidth2::Width2

Specifies the width of the straps. This value is optional. If Width2 is equal to zero, then the strap graphics are not included.

IJUAhsThickness2::Thickness2

Specifies the thickness of the straps. This value is optional. If Thickness2 is equal to zero, then the value is ignored. If Width2 is greater than zero and Thickness2 is equal to zero, then the straps are the same diameter as the insulation. If both Width2 and Thickness2 are greater than zero and there is more than one layer, the software applies the thickness based on the diameter of the outermost layer as shown below:

IJUAhsOffset2::Offset2

Specifies the offset from the end of the insulation to the straps. This value is optional. If Offset2 is equal to zero, then the value is ignored. If there is more than one layer, then the offset is applied based upon the length of the outermost layer.