Top Plate Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

IJUAhsLength2::Length2

Specifies the length of the top plate. Length2 is an optional property and if you do not assign a value, the software does not display the top plate.

IJUAhsWidth2::Width2

Specifies the width of the top plate. Width2 is an optional property and if you do not assign a value, the software does not display the top plate.

IJUAhsThickness2::Thickness2

Specifies the thickness of the top plate. Length2 is an optional property and if you do not assign a value, the software does not display the top plate.

IJUAhsTLCorner2::TLCornerType2

Specifies the corner type of the top plate. Use codelist value 1 for this corner type. See the hsCornerShape sheet from the HS_S3DParts_Codelist.xls workbook for all the valid codes. CornerType2 is applicable for all the vertical plates if the plate quantity is greater than 1.

IJUAhsTLCorner2::TLCornerX2

Specifies the horizontal size of the rectangular notch. TLCornerX2 takes a positive value and must be less than the Width1 value.

IJUAhsTLCorner2::TLCornerY2

Specifies the vertical size of the rectangular notch. TLCornerY2 takes a positive value and must be less than the Height1-Thickness1 value.

IJUAhsTLCorner2::TLCornerRadius2

Specifies the radius of the angled notch shape. Use the TLCornerRadius2 value when the two outside points of the notch must be rounded using the corner radius value.