Bolt Part Data Sheet - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Piping Reference Data

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Reference Data
Version_S3D
12.1(2019)

The Bolts node (the BoltPartData sheet in the Piping Catalog.xls workbook) defines the bolts that you want in your parts catalog.

  • The use of the Smart 3D reference data identification number as the catalog part number for a bolt is currently not supported.

  • If the part number column exists on the part class sheet, a unique, non-blank value must exist or the part is not created.

Industry Commodity Code (Required)

Specify the industry commodity code for the part.

All industry commodity codes must be unique across the entire catalog.

Bolt Type (Required)

Specify the bolt type shown as a Codelist value (stud, machine, cap screw, and so forth). The software determines the quantity of nuts and washers on the basis of the bolt type. For machine bolts, a nut and a washer are required for each bolt. One supplementary nut and washer may optionally be required for a machine bolt.

For studs, a nut and a washer are required for each end of the stud. In other words, a stud requires two nuts and two washers. One supplementary nut and washer may optionally be required for each end of a stud.

For cap screws, only a washer is required for each screw. A supplementary washer may optionally be required.

Valid codes are listed in the AllCodeLists.xls workbook on the BoltType sheet in the Codelist Number column.

Geometry Industry Standard (Optional)

Select the source used in the preparation of the catalog data applicable to the piping specialty item. Valid codes are listed in the AllCodeLists.xls workbook on the GeometricIndustryStandard sheet in the Codelist Number column.

Materials Grade Practice (Required)

Select the material grade practice.

Materials Category (Required)

Select Bolting materials.

Material Grade (Required)

Specify the material grade for the part. Valid codes are listed in the AllCodeLists.xls workbook on the MaterialGrade sheet in the Codelist Number column.

Coating Requirement (Optional)

Select the coating requirement.

Coating Type (Optional)

Specify the coating type for the bolt. Valid codes are listed in the AllCodeLists.xls workbook on the CoatingType sheet in the Codelist Number column.

See Also

Piping Parts