Nut Part Data Sheet - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Piping Reference Data

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.1(2019)

The Nuts node (the NutPartData sheet in the Piping Catalog.xls workbook) defines the nuts that you want in your parts catalog.

  • The use of the Smart 3D reference data identification number as the catalog part number for a nut symbol is currently not supported.

  • If the part number column exists on the part class sheet, a unique, non-blank value must exist or the part is not created.

Coating Requirement (Optional)

Select the coating requirement for the nut.

Coating Type (Optional)

Select the coating type for the nut.

Geometric Industry Practice (Optional)

Select the source used in the preparation of the nut catalog data.

Geometric Industry Standard (Optional)

Select the source used in the preparation of the nut catalog data.

Industry Commodity Code (Required)

Type a commodity code for the nut. The software uses this commodity code to find the nut in the parts catalog. This code must be unique across the catalog.

Material Category (Required)

Select the material category.

Material Grade Practice (Required)

Select the material grade practice.

Material Grade (Required)

Specify the material for the nut. Valid codes are listed in AllCodeLists.xls workbook on the MaterialGrade sheet in the Codelist Number column.

Nut Height (Required)

Enter the nut height. This height is used for the bolt length calculation for both studs and machine bolts from the bolted end generic data. Include the unit of measure, for example mm or in, when defining this value.

Nut Type (Required)

Specify the nut type (hex, square, and so forth). Valid codes are listed in AllCodeLists.xls on the NutType sheet in the Codelist Number column.

See Also

Piping Parts
Nut Part Data Sheet
Nut Selection Filter