These properties specify the attributes of the horizontal base plate of the welded beam attachment which will be attached to the existing structure. The base plate must be included.
For these properties, the default unit of distance is mm. Specify in at the end of the dimensional value to use inches (for example 10in).
IJUAhsWidth2::Width2
Specifies the width of the base. The value must be positive. If the value is set to zero, the Width1 value will be used by the software.
IJUAhsLength2::Length2
Specifies the length of the base. The value must be positive. If the value is set to zero, then the software sets the value by calculating Gap1 + 2 x Thickness1.
IJUAhsThickness2::Thickness2
Specifies the thickness of the base. The value must be positive. If the value is set to zero, then the Thickness1 value will be used by the software.
IJUAhsOffset2::Offset2
Specifies the left-to-right offset of the base from the bolt center. The value must be positive. The edge of the base will be located the specified distance from the bolt centerline. If the value is set to zero, the base plate will be centered. This value is used when the welded beam attachment bolt part is used for non-symmetrical beam attachments.
IJUAhsGap2::Gap2
Specifies the inside gap between the two side plates. If the value is set to zero, the wings will not be drawn.