These properties specify bolt/pin properties of a welded beam attachment and are used to set the pin/bolt size and the port location.
If Pin1diameter and Pin1Length are set to zero, then the pin/bolt is not drawn. You must change the port to an appropriate hole type in the HS_S3DParts.xls workbook and a separate bolt/pin will need to be modeled.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the bolt/pin. Use this property as a connection diameter from AIR when joining between the clevis and eye nut. If this value is set to zero, then the pin is not drawn.
An AIR that joins a clevis to an eye nut reads Pin1Diameter from the clevis and passes it into the PinDiameter prompt of the EyeNut.
IJUAhsPin1::Pin1Length
Specifies the length of the bolt/pin. If this value is set to zero, then the pin is not drawn.