Rod End Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

These properties specify the end shape for Strut_B.

IJUAhsRodEnd1::RodEnd1Type

Specifies the graphic shape to be used at Rod End. The value for this column is a codelist number and valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsRodEndType sheet. Enter the codelist short name for readability in XLS file. The nut (female) uses the same graphic shape as the bolt, but the port orientation is reversed. The port location (red dot) is at z=Length.

1 – Plain (Default, no additional graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

JUAhsThickness1::Thickness1

Specifies the thickness of the rod end. This value can be negative for Type 4 - Bolt and Type 5 - Nut.

1 – Plain (no effect on graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

IJUAhsLength1::Length1

Specifies the length from the base of the spade to the port location, which is also the start of the curved end. Only zero or positive values are allowed. This property is valid for spade end type only.

IJUAhsDiameter1::Diameter1

Specifies the outside diameter of the rod ends.

1 – Plain (no effect on graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

IJUAhsGap1::Gap1

Specifies a double-spade end or a single-spade end. If this value is zero, then a single-spade is drawn. If this value is a positive number, then a double-spade is drawn with two identical spades separated by the gap value defined here.