Known Issues - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports Assemblies

3D Design and Visualization
Intergraph Smart 3D
Reference Data
  1. For Type I assembly, if you give snip steel properties, then the steel will become cutback steel to snip steel. For sloped steel, snip for the section is not given because some structure angle may be a positive angle. Presently, snip steel does not allow a positive angle. Because of this, the section will be shown as follows:

  2. A similar problem exists for Type U and Type L assembly as well, but only for the welded connection type.