Model from a P&ID - Intergraph Smart 3D - Help

Intergraph Smart 3D Piping

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Help
SPFVersion_custom
10
Version_SThreeD_Custom
10.1 (2014 R1)
  1. Click SmartPlant > Retrieve to retrieve the P&ID that contains the pipe to place. You can skip this step if the P&ID has already been retrieved.

  2. Click SmartPlant > View P&ID to view the P&ID that contains the pipe to place.

  3. In the P&ID, select the point from which to start modeling.

    The point highlights in the model.

  4. Click Tasks > Piping to start the Piping task if necessary.

  5. Click Route Pipe .

    If the object from which you are routing is already correlated, the New Pipe Run dialog box displays with the parameters associated with the pipe run.

  6. Click OK on the New Pipe Run dialog box.

  7. Route the pipe to meet your requirements.

  • You can insert components while you are routing pipe. With the Route Pipe command active, click Insert Component ., and then select the component from the P&ID. Click Finish on the Insert Components ribbon bar. The software inserts the component on the end of the run and then continues with the Route Pipe command. Do not right-click to reset the command, or you must restart the command.

  • You can insert components after you route pipe. Click Insert Component , select the run, and then select the component from the P&ID. Click Finish on the Insert Components ribbon to place the component in the model. If the attribute information has already been retrieved, the software places that component. If the attribute information has not been retrieved, the software displays an error message telling you that the component cannot be located.