Extend an existing arc pipe - Intergraph Smart 3D - Help

Intergraph Smart 3D Piping

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Help
SPFVersion_custom
10
Version_SThreeD_Custom
10.1 (2014 R1)
  1. Click Route Pipe on the vertical toolbar.

  2. Click Arc Routing to change the route mode from straight to arc.

  3. Select the end feature from which to extend the arc pipe run.

  4. Select a center point to specify the direction and normal for the arc.

  5. Type the arc radius. If you need to route the arc with the same radius, select Maintain Same Radius in the Arc Radius drop-down list.

    The center point is adjusted according to the radius value.

  6. Select the end point.

  7. In the Arc Angle, key in the required angle.

  8. Route the arc pipe as needed.