Could not create the enumerator (Structural Detailing) - Intergraph Smart 3D - Administration

Intergraph Smart 3D Troubleshooting Reference

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Administration
Version_S3D
12.x(2018)

Could not create the enumerator (Structural Detailing)

Meaning: Failed to create enumerator object. In a case where this could have happened, it was for the split with planning seams. Therefore, the profile (stiffener or beam) part has not been created or updated. This could be a memory problem.

Recovery: Try restarting the command, restart the session, or reboot the computer to verify that all computer memory has been released. Verify that all inputs are good and are not on the To Do List. Make any necessary corrections. If problem still exists, report steps taken to your support group.