Place a set-on cross - Intergraph Smart Isometrics - Help - Hexagon PPM

Intergraph Smart Isometrics Help

PPMProduct
Intergraph Smart Isometrics
PPMCategory_custom
Help
SPFVersion_custom
2019 (10.0)
Version_IConfig
6.0(2016)
Version_ISOGEN
13.0(2016)
Version_SPIso
7.0(2019)
Version_SPSplgn
9.0(2019)
  1. Click the Fitting list on the Place toolbar, and then select Set On Cross.

  2. In the Bore Box, select the bore of the branch of the set-on cross. By default, the bore size is the same as the original pipe.

  3. Click a section of pipe and route again.

    The resulting sketch appears similar to the example. Notice that instead of placing a set-on cross, the software places a set-on tee. A set-on cross must connect two elements.

  4. Click Fittings again to route the second element. Because the software remembers your previous selection, you do not need to expand the Fittings list and select Set On Cross again.

  5. Click near the set-on tee that you placed previously.

  6. Move away from the set-on tee, and then click again.

    The resulting sketch resembles the example.

As indicated in the Pipeline Explorer, both components are set-on crosses (CRSO). Upon placement of the second element, the software automatically converts the set-on tee to a set-on cross.