Message
Member system Type property cannot be 0.
Severity
High.
Detailed Description
The type property on the member system has not been set. This property varies with the type category on the member. For example, a member system with type category of Beam would have a type of Beam, Purlin, Girder, Girt, or Joist.
Possible Cause
The likely cause of this error is that a custom command was written to place a member system, and the type property was not set on the member system.
Possible Impacts
Without the type property, any member system that attempts to connect to this member system will not establish the appropriate frame connection when the connection is By Rule.
What You Should Do
Manually update the member system type property.
-
Open the model.
-
Select the member system part.
-
On the ribbon, select the appropriate member type property.