Meaning: The trench straight feature between two trench turn feature cannot be created because:
-
The Sketch 3D segment length is too low.
-
The projection values of the trench turn feature are too high.
Recovery:
-
In the Workspace Explorer, select the trench run that is in error.
-
Click Path .
-
Increase the length of the Sketch 3D path so that the trench run can accommodate straight feature
-
Click Finish on the path ribbon, and then click Finish on the command ribbon.
-OR-
-
In the Workspace Explorer, select the trench straight feature that is in error.
-
Click Properties .
The Trench Straight Feature Properties dialog box displays.
-
On the General tab, select Dimensions in the Category box.
-
Modify the projection values.
-
Click OK.
-
Click Finish on the command ribbon.