Meaning: Failed to create/update the profile part. Therefore, the profile (stiffener or beam) part has not been created or updated. Failed to retrieve at least one collection of inputs associated to the profile part. This could be the plate and/or boundaries and/or cross section and/or landing curve. This may be caused by a database corruption or a computer memory problem.
Recovery:
-
Restart the command.
-
Restart the session.
-
Reboot the computer to verify that all computer memory has been released.
-
Check your database integrity.
-
Verify that all inputs are good and are not on the To Do List. Make any necessary corrections.
-
If problem still exists, report steps taken to your support group.