One of the arguments of this operation was of the incorrect type - Intergraph Smart 3D - Administration

Intergraph Smart 3D Troubleshooting Reference

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Administration & Configuration
Version_S3D
12.1(2019)

Meaning: Failed to create/update the profile part. Therefore, the profile (stiffener or beam) part has not been created or updated. The inputs for the creation of a profile part are a cross section, landing curve and a plate. The input received was not one of them.

Recovery:

  1. Verify that all inputs (plate, landing curve and cross section) are good and are not on the To Do List. Make any necessary corrections.

  2. If problem still exists, report steps taken to your support group.