Failed to create a required object - Intergraph Smart 3D - Administration

Intergraph Smart 3D Troubleshooting Reference

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Administration & Configuration
Version_S3D
12.1(2019)

Meaning: A required object could not be created, therefore the geometry utility could not properly finish the service requested. This is probably a memory problem and should never happen.

Recovery:

  1. Restart the command.

  2. Restart the session.

  3. Reboot the computer to verify that all computer memory has been released.

  4. Verify that all inputs are good and are not on the To Do List. Make any necessary corrections.

  5. If problem still exists, report steps taken to your support group.