Add scaling by edge shrinkage - Intergraph Smart 3D - Help

Intergraph Smart 3D Structural Manufacturing

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Help
Version_S3D
10.1(2014R1)
  1. Click Shrinkage .

  2. On the Shrinkage ribbon, select the Mode that meets your requirements.

  3. Click Plates/Profiles/Assembly .

  4. Select the parts to which you want to add shrinkage.

    • You can select the parts in the model, or from the Workspace Explorer.

    • Because of the different ways in which shrinkage is applied to plates and profiles, you can only select one type at a time.

  5. Click Primary Direction .

  6. Select a line to indicate the primary direction for the shrinkage.

  7. Click Secondary Direction .

  8. Select a line to indicate the secondary direction for the shrinkage.

  9. Type a value in the Primary Factor box.

  10. Type a value in the Secondary Factor box.

    If no shrinkage is needed in the secondary direction, then a Secondary Factor of 1.00 should be used.

  11. Click Finish.