The Approved hole is missing a relationship to the structure part being cut - Intergraph Smart 3D - Administration & Configuration

Intergraph Smart 3D Database Integrity Administration

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Administration & Configuration
Version_S3D
12.1(2019)

Message

The Approved hole is missing a relationship to the structure part being cut.

Severity

Crucial.

Detailed Description

To be able to place the hole on the To Do List when a planning seam or straking seam is applied to the structure, a new relationship was needed between the hole and the structure part being cut. This relationship is missing from the hole in error.

Possible Cause

The hole may have been created in an older version of the software, and the migration command failed to create the relationship.

Possible Impacts

If a planning seam or straking seam is applied to the structure being cut, the hole will not be placed on the To Do List.

What You Should Do

  1. Open the model.

  2. Run the Clean Database custom command in order to place the proper relationship.