The Sketching Plane of Sketched Feature should not be from Cut Geometry - Intergraph Smart 3D - Administration & Configuration

Intergraph Smart 3D Database Integrity Administration

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Administration & Configuration
Version_S3D
12.1(2019)

Message

The Sketching Plane of Sketched Feature should not be from Cut Geometry.

Severity

Crucial.

Detailed Description

The input port that defines the sketch plane for a sketch feature cannot be from the geometry that is cut by the sketch feature. The feature creation command normally prevents the selection of a port on the wrong geometry. If the Database Integrity check finds a sketch feature that is using an improper port, it reports the problem. If the database integrity repair command is run on any one of these features, it replaces the improper port with an equivalent port from the proper geometry for each reported feature. The repair command repairs all problems of this type if any one feature is repaired.

Possible Cause

Unknown.

Possible Impacts

The final part geometry is not created.

What You Should Do

  1. Ask your database administrator to back up the model.

  2. Open the model.

  3. Run the Clean Database custom command.

  4. Select the check box for the sketch feature you want to fix, and then click Clean Now.