Starting and Stopping Batch Services - Intergraph Smart 3D - Installation

Intergraph Smart 3D Installation

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Installation
SPFVersion_custom
2019 (10.0)
Version_S3D
12.1(2019)

When you install Batch Services software, the batch server service is configured to start automatically each time you restart your computer. No further configuration is required. Intergraph recommends leaving the batch server service as configured. However, if you want to configure Batch Services to start manually, do the following:

  1. Open Control Panel > Administrative Tools > Services.

  2. In Services, right-click Intergraph Batch Server, and select Properties.

  3. Set Startup type to Manual, and then click OK.

  4. Close the Services window.

    Batch Services also delivers an Intergraph NQS Listener service that is configured to start automatically. If your site is not using Intergraph NQS, you can configure the NQS Listener service to start manually. Repeat steps 1-3, selecting Intergraph NQS Listener from the Services list.

If you configure Batch Services to start manually, you must start the batch server each time you restart your system, or each time you want to run Batch Services.

To start Batch Services manually:

  1. Open Control Panel > Administrative Tools > Services.

  2. In Services, select Intergraph Batch Server, and then click Start.

To stop Batch Services:

  1. Open Control Panel > Administrative Tools > Services.

  2. In Services, select Intergraph Batch Server, and then click Stop.