Bracket Flange Properties Tab (Bracket Plate System Properties Dialog Box) - Intergraph Smart 3D - Help

Intergraph Smart 3D Molded Forms

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Help
Version_S3D
10.1(2014R1)

Specifies the default values for the bracket flange parameters. Values can be modified as permitted by the catalog. This tab is only visible after bracket creation and only if the bracket has a flange.

Molded Surface Side

Sets the molded side of the bracket and bracket flange. Supports creation of the flange symbol at the correct location while accounting for molded convention thickness direction and offset values.

  • If the molded side is the inner surface, the value is 0.

  • If the molded side is the outer surface, the value is 1.

Flange Width

Width of the flange measured from the edge of the bracket symbol, which is also the first bend tangent.

Plate Thickness

Specifies the thickness of the plate.

Bend Angle

Angle between the flange surface and bracket surface.

Inner Radius

Bend radius measured along the inner surface of the bend.

1

FlangeWidth

2

PlateThickness

3

BendAngle

4

InnerRadius

One option is also displayed.

Flange Orientation

Select the orientation of the flange bracket.

  • Same As Parent - Orientation is the same as the bracket plate system primary profile orientation.

  • Against Parent - Orientation is in the opposite direction of the bracket plate system primary profile orientation.