Bracket System Properties Dialog Box - Intergraph Smart 3D - Help

Intergraph Smart 3D Molded Forms

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Help
Version_S3D
10.1(2014R1)

Specifies the properties for the root or leaf bracket system that you are editing.

OK

Accepts the values, and closes the dialog box.

Cancel

Rejects the values, and closes the dialog box.

Apply

Accepts the values, but does not close the dialog box.

  • A leaf system always shares the same property values as its root system upon creation.

  • When a root and leaf system have properties with the same values, a change to a root system value changes the leaf system value.

  • When you change the value of a property of a leaf system, later changes to that property on the root system do not change the leaf system value.

  • When a root system is split, new leaf systems are created that inherit the property values of the root system, except for values on the original leaf system that are changed before the split.

  • Some leaf system properties cannot be changed at the leaf system level. They must be changed at the root system level.

Main Tab (Bracket System Properties Dialog Box)

Material Tab (Bracket System Properties Dialog Box)

Molded Conventions Tab (Bracket System Properties Dialog Box)

Selection Tab (Bracket System Properties Dialog Box)

Parameters Tab (Bracket System Properties Dialog Box)

Flange Selection Tab (Bracket System Properties Dialog Box)

Flange Parameters Tab (Bracket System Properties Dialog Box)

Bracket Connect Points Data Tab (Bracket System Properties Dialog Box)