Curves (Geometric Construction Palette Dialog Box) - Intergraph Smart 3D - Help

Intergraph Smart 3D Molded Forms

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Help
Version_SThreeD_Custom
10.1 (2014 R1)

The following geometric construction interfaces create lines and curves.

Each command supporting the option displays tabs and interfaces appropriate to the command.

Curve by Points on Surface - Creates a curve by interpolation through a set of points. Some points can be designated as knuckles so that the curve has discontinuous tangency. For more information, see Curve by Points on Surface.

Curve by Two Points on Surface - Creates a curve between two points projected onto a surface. The curve can be created with or without extensions at each end. For more information, see Curve by Two Points on Surface.

Fillet by Curve - Creates a blended fillet of a specified radius between two curves that are end-connected and projected onto a surface. For more information, see Fillet by Curve.

Curve by Curves - Creates a single curve from two or more end-to-end curves. For more information, see Curve by Curves.

Curve by Intersection - Creates a curve along the intersection of two surfaces. For more information, see Curve by Intersection.

Curve at Offset by Intersection - Creates a curve offset from the intersection of a surface or plane with a surface. For more information, see Curve at Offset by Intersection.

Line from Coordinate System - Creates a line along a coordinate system axis. For more information, see Line from Coordinate System.

Line by Points - Creates a line between two points. For more information, see Line by Points.

Parallel Line - Creates a line parallel to another line. For more information, see Parallel Line.

Line by Point, Angle, and Length - Creates a line at a defined angle and length on a coordinate system plane. For more information, see Line by Point, Angle, and Length.

Line String by Points - Creates a line string between a series of two or more points. For more information, see Line String by Points.

Edge from Curve or Surface - Creates a curve at an edge of a surface, such as a plate, the landing curve of a profile, or a solid. For more information, see Edge from Curve or Surface.

Edges from Curve or Surface - Creates one or more curves at each edge of a surface, such as a plate, the landing curve of a profile, or a solid. For more information, see Edges from Curve or Surface.

Polyline by One to Four Segments - Creates a polyline string of up to four curves by defining point coordinates on a reference plane. For more information, see Polyline by One to Four Segments.

Curve as Extended Section - Copies polyline cross-sections. For more information, see Curve as Extended Section.