Register the Site Database for P&ID Access - Intergraph Smart 3D - Installation

Intergraph Smart 3D Installation

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Installation
Version_S3D
10.1(2014R1)

Before you complete the steps in this procedure, you must install the Piping Specification Remote Access Server service and configure the COM+ application. For more information, see Install Smart 3D Client Software.

You must have administrator privileges on the computer in order to perform this installation procedure.

  1. Click Start > Run, and then click Browse in the Run dialog box.

  2. Navigate to [Product Folder]\RefData\Tools\Bin\SetSiteForPipingSpecRemoteAccess.exe, and click OK.

  3. Click OK in the Run dialog box.

  4. In the Set Site Database for Piping Spec Remote Access dialog box, enter the Site and Site schema database names and servers in the appropriate fields.

  5. Click OK.

  • In order to use Piping Specification Remote Access you must perform additional installation and configuration on the computers running SmartPlant P&ID. See the Installing SmartPlant 3D Piping Specification Remote Access Client section in the SmartPlant P&ID Installation and Upgrade Guide for more information about installing the SmartPlant 3D Piping Specification Remote Access Client. Also, see the Piping Specification Utility section in the SmartPlant P&ID Utilities Guide for additional configuration information.

  • The "server" used by the SmartPlant 3D Piping Specification Remote Access Client and the SP3D P&ID Client Tester application is the computer on which the SmartPlant 3D Piping Specification Remote Access Server COM+ application has been installed and configured. This server can be different from the database server on which the Site database server and Site schema server reside.

See Also

Integrating with SmartPlant P&ID