Shape at Edge Overlap - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Structural Detailing Reference Data

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Reference Data
Version_S3D
12.1(2019)

Value

Extend Near Corner

Offset Near Corner
Offset = 0.0mm

Offset Near Corner

None

The purpose is to maintain maximum contact between the bounded and bounding objects.

FaceToInsideCorner

The purpose is to clear all material from the inside of the bounding edge.

FaceToEdge

The purpose is to clear all material from the inside of the bounding edge and in the vicinity of the inside corner.

FaceToOutsideCorner

The purpose is to clear all material from the inside of the bounding edge and the bounding edge itself. If there is no overlap on the outside then it behaves as Face To Outside.

FaceToOutside

The purpose is to clear all material from the inside of the bounding edge, the bounding edge itself, and in the vicinity of the outside corner. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained.

InsideToEdge

The purpose is to clear material in the vicinity of the inside corner. If the overlap at the bounding edge is insufficient for the default feature, it behaves as Inside To Outside.

InsideToOutsideCorner

The purpose is to clear material from the bounding edge and in the vicinity of the inside corner. If there is no overlap on the outside then it behaves as Inside To Corner.

InsideToOutside

The purpose is to clear all material from the bounding edge and in the vicinity of both corners. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained.

InsideCornerToOutside

The purpose is to clear material from the bounding edge and in the vicinity of the outside corner. If there is no overlap on the top, the cut progresses to the bounded top. If the outside area is set back from the near corner, the offset value (separate question) is maintained.

EdgeToOutside

The purpose is to clear material in the vicinity of the outside corner. If there is no overlap on the outside, the cut progresses to the outside of the bounded member. If the outside area is set back from the near corner, the offset value (separate question) is maintained.