You can link directly to this document using https://docs.hexagonppm.com/go/S3D11HVAC
The following changes have been made to the HVAC task.
Hotfix and Service Pack Updates
-
You can now correlate 3D ducting objects to the corresponding P&ID objects so that you can propagate attributes, perform design consistency checks, and so on. For more information, see HVAC in the Integrated Environment. (P2 CP:311119)
-
Added information about free leg behavior. For more information, see Free Leg in Understanding the types of duct features. (P2 CP:319923)
Version 2016 (11.0)
-
Added a new locate filter, Construction Graphics. For more information, see Select. (P2 CP:271166)
-
Added a new Quick Route
command that enables you to join two existing duct segments. For more information,
see Quick Route Command. (P1 CP:248716; P1 CP:248717; P3 CP:288004)
-
You can now set the software to remember the last used working plane when routing duct. For more information, see Defaults Tab (Duct Properties Dialog). (P4 CP:258470)
-
You can now move or delete at boundary connections maintaining the ducting design intent. (P2 CP:249685, P2 CP:267185, P2 CP:268379, P2 CP:264940, P2 CP:248568, P2 CP:300832)
-
You can select a section of ducting network using the new route selection commands. For more information, see Route Selection Commands. (P1 CP: 248690, P2 CP:293434, P1 CP:297357)
-
You can slide a branch leg along a header run without disconnecting the branch. For more information, see Move a branch along the header. (P2 CP:293434)
-
Added a new Disconnect command that allows you to disconnect route objects without disturbing the rest of the network. For more information, see Disconnect Command. (P2 CP:293435)
-
You can now select a straight feature on a run, and move it to connect to an adjacent run. For more information, see Modify a set of features. (P2 CP:300832)