Sets the primary units for dimensions.
Linear
Specifies the unit settings for a linear dimension.
Units
Sets the primary units for linear dimensions.
Unit Label
Sets the unit label. You can type up to 20 characters for a unit label.
Subunit Label
Sets the subunit label. You can type up to 20 characters for a subunit label.
RoundOff
Sets the roundoff for the value. This control is sensitive to the unit setting (decimal or fractional) and contains values appropriate for the unit. This control is also sensitive to the dimension that you place and contains values appropriate for the dimension.
Maximum Subunits
Sets the maximum subunits value. You can type a value up to 255. This value applies to feet and inches. For example, if you type 13, the dimension appears as 13 inches and not 1 foot and 1 inch.
Angular
Sets the units for an angular dimension.
Units
Sets the primary units for angular dimensions. Options are Degrees, DegMinSec, or Radians.
RoundOff
Sets the roundoff for the value. This control is sensitive to the unit setting (decimal or fractional) and contains values appropriate for the unit. This control is also sensitive to the dimension that you place and contains values appropriate for the dimension.
Zeroes
Specifies if a zero is on the left or right of the decimal in a dimension.
Leading
Places a zero to the left of the decimal point if no numbers appear to the left.
Trailing
Places zeros to the right of the decimal point. The number of zeros placed is based on the active setting for RoundOff. For example, if the dimensional value is .5, and the roundoff setting is .1234, the dimensional value appears as .5000.
Delimiter
Specifies the decimal delimiter for a dimension.

Period — Sets a period as the decimal delimiter.

Comma — Sets a comma as the decimal delimiter.

Space — Sets a space as the decimal delimiter.