Drawing Basic Elements - SmartSketch - Help

SmartSketch Help

PPMProductFamily
Engineering and Schematics
PPMProduct
SmartSketch
PPMCategory
Help
Version_SPEM_custom
9.0.0
Version_SSK
9.0(2015)

An element is any line, circle, or other part of the drawing. The Draw toolbar on the left side of the drawing sheet contains most of the buttons that you can use to draw any type of basic geometric element—freeform shapes, lines, arcs, circles, and so forth.

You can place most basic elements with just a few clicks. For example, if you want to place a line, you can click Line/Arc Continuous ( or ) on the Draw toolbar. Then, click two points to indicate where to start and finish the line. If you do not want to place another line, you can right-click to end the operation.

Right-clicking ends most operations in the software.

You can also place the line by clicking Line/Arc Continuous ( or ) and then clicking and dragging the pointer. When you release the mouse, the line appears on the drawing sheet. With this method, you drag the pointer as if it were a pen. You can draw most elements, such as rectangles, circles, and arcs, with this method, sometimes called mouse-down drawing. The mouse-down method is typically used to place most elements in conceptual sketching and modification.

If you want to place a precise line, click Line/Arc Continuous ( or ), type values into the ribbon that appears, and then press ENTER. You can then click on the drawing sheet to place the line. This method, sometimes called mouse-up drawing, is typically used for precision placement and when you want to draw elements that are related to each other.

In some cases, you might want to click points on the drawing sheet and type values in the ribbon to place an element. For example, you can click Line/Arc Continuous ( or ) and then type 3.0 in the Length box on the ribbon box and press ENTER to lock the length value.

When a line that is three inches long appears next to the pointer, you can click anywhere on the drawing sheet to indicate where to place one end of the line. Then, you move the line around and click again to set the line's orientation angle.

If you do not like the results of what you drew, you can click Undo on the Main toolbar. If you want to repeat an action, click Redo on the Main toolbar.

See Also

Drawing FreeForm Shapes
Drawing Lines
Drawing Squares, Rectangles, and Polygons
Drawing Circles, Arcs, and Ellipses