Liner Thickness Data Sheet - Intergraph Smart 3D - Help

Intergraph Smart 3D Catalog

PPMProductFamily
3D Design and Visualization
PPMProduct
Intergraph Smart 3D
PPMCategory
Help
Version_S3D
12.x(2018)

The Liner Thickness Data node (the LinerThicknessData sheet in the Piping Catalog.xls workbook) defines generic data for liner thicknesses.

Geometric Industry Standard (Required)

Enter the code that represents the manufacturer of the lined fittings. Valid codes are listed in the AllCodeLists.xls workbook on the GeometricIndustryStandard sheet in the Codelist Number column.

Lining Material (Required)

Type the code that defines the lining material. Examples of lining material include epoxy, rubber, and plastic. Valid codes are listed in the AllCodeLists.xls workbook on the LiningMaterial sheet in the Codelist Number column.

Liner Thickness at Inside Diameter (Required)

Type the thickness of the lining material at the inside diameter of the piping.

Liner Thickness at Face of Flange (Conditionally Required)

Type the thickness of the lining material at the face of flange.

Nominal Piping Diameter (Required)

Type the nominal piping diameter for the applicable end.

Nominal Diameter Units (Required)

Specify the units for the NPD column. For example, type mm or in.

Optional Liner Thickness at Face of Flange (Conditionally Required)

Type the optional thickness of the lining material at the face of flange. This is the liner thickness that will be used in the bolt length calculations.