The Stop assembly uses the following attributes. If the combined support does not include any Stop assembly, you can ignore these attributes.
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhs_StopStructConn:: |
Specifies whether the Limit Stop secondary support connects to the top of the supporting structure or the bottom of the Shoe. This attribute uses the hsStructConnection codelist from the DDS_Assy_Codelist workbook. |
1 = Below Shoe 2 = Above Structure |
IJUAhsStopGap:: |
Specifies the gap for the Limit Stop. |
Stop below the Shoe - The Stop gap is measured to the edge of the supporting section Stop above the supporting structure - The Stop gap is measured to the edge of the Shoe |