A Rod Hanger support uses the following general attributes:
Name |
User Name |
OA |
Category |
On Property Page |
Read Only |
---|---|---|---|---|---|
SupportNumber |
Support Number |
No |
Standard |
Yes |
Yes |
SequenceNo |
Sequence Number |
Yes |
Standard |
Yes |
No |
RodDiameter |
Rod Diameter |
Yes |
Standard |
Yes |
No |
StructureAtt |
Structure Attachment |
No |
Standard |
Yes |
Yes |
PipeAtt |
Pipe Attachment |
No |
Standard |
Yes |
Yes |
CheckPipeSize |
Check Pipe Size |
No |
Standard |
No |
Yes |
BotRodLength |
Bottom Rod Length |
Yes |
Standard |
Yes |
No |
The above mentioned Rod Diameter attribute applies to the Constant Spring Rod hanger. This is a read-only attribute for the Rigid and Variable Rod Hangers.
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJOAhsBOM_SequenceNo:: SequenceNo |
Specifies the support sequence number. You can use this attribute in a custom BOM definition or leave it blank. |
|
IJUAHgrURS_RodDiameter:: RodDiameter Or IJUAHgrURS_CSRodDiameter:: RodDiameter |
Specifies a numerical value for the rod diameter. This is used to select the correct parts, such as nut and rod for the rod hanger. |
|
IJUAHgrURS_StructureAtt:: StructureAtt |
Specifies the name of the Top sub-assembly that the support uses. |
|
IJUAHgrURS_PipeAtt::PipeAtt |
Specifies the name of the Bottom sub-assembly that the support uses. |
|
IJUAHgrURS_BotRodLen:: BotRodLength |
Specifies the length of the Bottom Rod that is used with a Turnbuckle only. The length is also used for the Bottom Rod length on the Spring Rod Hanger without the Turnbuckle. |