You must define the corresponding attributes on the SmartPart for the following attributes as occurrence attributes for the support assembly to set them. If the attributes are not OAs, the support assembly cannot set the values on the U-Bolt SmartPart.
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhs_UBoltGap:: |
Specifies the U-Bolt gap. |
The following definitions are supported: 1 - Gap between outside of pipe and inside of U-Bolt. |
IJUAhs_UBoltBotGap:: |
Specifies the U-Bolt bottom gap value. |
The following definitions are supported: 1 - Gap between outside of pipe and the supporting structure. |
IJUAhs_UBoltDblSpace:: |
Specifies the offset value for the second U-Bolt. |
The following values are supported: 1 - Gap between the centers of bolts. |
IJUAhs_UBoltSideGap:: |
Specifies the side gap for the U-Bolt. |
The following values are supported: 1 - Gap between the outside of the pipe and inside of the U-Bolt. |
For more information on how to use dimensional attributes, see Input Values.